I am currently receiving syslog feeds from network devices to my VMS/Security Monitor (2.2/1.2.3 respectively). It's listening on UDP 514 and forwarding to 52514 like it is supposed to. However, where can I view the syslog data that is being received...

Every time I attempt to run a report from IDSMC or Security Monitor the application freezes up. I'm using v 1.2.3 IDSMC. I keep the database relatively clean and pruned, so I can't figure out why reporting is not functioning.

I am evaluating CTR 2.0 (have VMS 2.1 in production). I am attempting to get alarm feeds going from CSIDS appliance sensors (4210's and 4230's) as well as ISS Real Secure event collectors. One of my CSIDS sensors is successfully sending alert informa...

Can anyone tell me how I would connect directly to the database that comes installed with VMS 2.1? What ODBC drivers should I use? I'm running it with the default installation settings (except for the password), so I know the password and port (10033...

I am attempting to synch my sensors with our time servers. They are running NTP with no authentication, but the sensor is requiring that I enter the key and key id. How can I get around this? It's very important that I have them synchronized.