About catalin

catalin · 02-05-2003

Hi,I have the following problem:100->PBX->pri->router3725-lan-router806->ata186->310where 100 and 310 are two phone extensionswhen I'm dialing from 310 to 100 the router is disconnecting with the message "Cause i = 0x82C1 - Bearer capability not imp...

catalin · 04-03-2003

Hi, check if you have enough DPS's!Regards!

catalin · 02-05-2003

I made it ..it was the codec...thanks

catalin · 09-27-2002

it seems to me that you can't configure the ip address before estabilish the encapsulation, so put the encapsulation first and after that try the ip address..

catalin · 09-27-2002

hi,try this, hope it will workconfreg 0x2reloadset boot config-register 0x2set boot system flash bootflash:cat4000.5-5-10.bin

Member Since	‎09-27-2002 12:03 AM
Date Last Visited	‎08-18-2017 03:51 AM
Posts	5

User Statistics

User Activity

PRI and ATA186

Re: cisco 26xx-not detecting FXS module

Re: PRI and ATA186

Re: Creating Sub interfaces for vlan routing

Re: 2948g