About rafische

rafische · 07-02-2003

When I perform the backup it works without a problem but when I try to restore after clearing the config with configmgr then running the configuration setup again then a reboot when I try to restore I get the error "error:53 file not found in proce...

rafische · 10-18-2002

I've just completed installing Unity 3.1(5) on the ICS 7750 in a training environment where I'm setting up Networking between two Organizations across two separate ICS boxes. Exchange is on a different blade than Unity and so I installed my SMTP con...

rafische · 10-01-2002

I'm installing 3.1(5) on a server with Exchange off-box. I've created an install account in the domain and have run through the install guide step by step to make sure this account has all the rights, permissions, etc. both on the local server and i...

rafische · 07-02-2003

Thank You that fixed the restore it worked nicely.

rafische · 07-02-2003

The version of DIRT is 1.0.0.218 Unfortunately I do not see a file only the info from earlier message.

rafische · 10-25-2002

You have to:1. Insert the Cisco Unity Service Packs disc in the Unity blade CD-ROM drive.2. Copy the SQL2000_SP1 directory to the root directory of drive C of the Unity blade.3. Remove the Cisco Unity Service Packs disc from the CD-ROM drive, and ins...

rafische · 10-21-2002

I assume you enabled this on both the Unity server and the system you're trying to map the network drive to, correct?

rafische · 10-18-2002

I experienced this exact same problem and finally got around it by enabling Netbios over TCP/IP in my network settings.

Member Since	‎09-30-2002 11:01 AM
Date Last Visited	‎08-18-2017 03:51 AM
Posts	10

User Statistics

User Activity

Dirt Recovery error on Unity 4.02

Extension Address Utility on Unity 3.1(5)

Unity Install Part 2 - Configuration Setup fails to start service on 3.1(5)

Re: Dirt Recovery error on Unity 4.02

Re: Dirt Recovery error on Unity 4.02

Re: Installing MSDE SP1 on ICS7750

Re: DiRT to mapped drive

Re: DiRT to mapped drive