About olazcano

olazcano · 04-30-2005

HiI’m trying to setup “external call transfer” in a CallManager Hybrid environment.This is how my network looks like: NexTone SBCCallManager Cisco 5850 Mediatrix 1204 Mediat...

olazcano · 03-24-2004

Dear All!I have an AS5850 configured as a SIP Gateway and as a H323 Gateway. I'm planning to use this equipment as an interconnection point between PSTN,SIP and H323.I already have a functional H323 Network with ISDN trunks to the pstn and it is work...

olazcano · 03-15-2004

HiThe problem i'm facing is the next:I have a Cisco AS5850 with an Euro ISDN trunk connected to a PBX. The pbx send out the calls in order the A5850 terminate these calls in a remote gateway. I receive only a maximum of 12 digits of the complete stri...

olazcano · 03-02-2004

HiI have a Cisco AS5850 with 24 E1. I need to interconnect one E1 link with a Mitel 3300. Unfortunately the cisco cannot match the inbound dial-peer and then the call never succeed and always the modems answer.I alreday confirm that the Mitel is send...

olazcano · 10-18-2003

HiI have an E1 link on a Cisco 2621 with a NM-1CEU1. The problem is that the controller never goes up, unless i have a loopback or a local physical loop, and the serial interface i have, after the sh interfaces, shows: serial 1/0:0 is reset, protocol...

olazcano · 08-17-2004

HiThis link is going to be useful for you. It's just a simple configuration.By the way, kiwi is a good tool. Just be aware of the file lenght where you store your logs, and try to make copies to avoid any loss of your records.Regards.http://www.cisco...

olazcano · 03-26-2004

Thank you very much for your attention. Now i understand whats going on, and i will go over the best solution.Thanks!Oscar.

olazcano · 03-25-2004

Thank yoy very much for your answer. If it is the situation, then how the SIP to VOIP Transfer calls works?I found a lot of documentation about this feature, and i though this is the required feature to perform SIP to H323 Termination.Please, let me ...

olazcano · 03-08-2004

Hi Thank you very much for your answer.I have found what i think is the problem. I opened a debug session in the Mitel link in order to look at the handshaking between the AS5850 and the Mitel, and what i got is that the trunk is seized properuly, th...

olazcano · 10-20-2003

Thanks for the advice! I'll try, because i still have the problem.If you know something else, or any other idea, please do not hesitate and tell me!Olazcano

Member Since	‎10-07-2002 10:38 AM
Date Last Visited	‎08-18-2017 03:51 AM
Posts	14

User Statistics

User Activity

EXTERNAL CALL TRANSFER - HYBRID CALLMANAGER ENVIRONMENT

SIP->h323 in a AS5850 - Not able to send h323 calls coming from a SIP Phone

NOT RECEIVING THE COMPLETE DIALED STRING FROM AN ISDN TRUNK PBX ->AS5850

AS5850->Mitel 3300 NO INBOUND PEER MATCHING

PROBLEM INTERFACE SERIAL - Serial 1/0:0 is reset, protocol is down

Re: AS5300:How to configure CDR log to Syslog server?

Re: SIP->h323 in a AS5850 - Not able to send h323 calls coming f

Re: SIP->h323 in a AS5850 - Not able to send h323 calls coming f

Re: AS5850->Mitel 3300 NO INBOUND PEER MATCHING

Re: PROBLEM INTERFACE SERIAL - Serial 1/0:0 is reset, protocol i