About msaltunsaray

msaltunsaray · 09-09-2019

Hi expert, I ve got a question about bgp cluster-id. I just would like to learn what is the difference between having cluster-id or not. I am recently configuring two new RRs for our network and curious whether I should configure cluster-id! Could yo...

msaltunsaray · 07-05-2019

Hi guys, If i have broadband customers via pppoe over fiber, how do i advertise their public IP addresses via iBGP to my RRs across the MPLS network? I do see customers public IP addresses in routing table with gateway <pppoe> and also see in BGP adv...

msaltunsaray · 05-17-2018

Hi experts, I would like to create an access-list and use it for vty line. The purpose is allow ssh traffic for only specific subnet and host. I have created one as below. configure terminal ip access-list extended ABC permit tcp 10.0.0.0 0.0.0.2...

msaltunsaray · 05-02-2018

Hi guys, Can anyone tell me that how do we configure BGP authentication with two RR routers? Same AS, IBGP peering... My RRs are 7301. Thanks in advance.

msaltunsaray · 05-01-2018

I would like to enable ospf bfd for all ospf interfaces. What is the default OSPF BFD default values if I dont configure interval, min-rx, and multiplier? System image file is "bootflash:/asr1002x-universalk9.03.10.01.S.153-3.S1-ext.SPA.bin"

msaltunsaray · 09-09-2019

Hello, Actually yes you can. So I have already configured two. I just want to learn what is the exact benefit of creating cluster-id? I know the difference of using same or different cluster-id! Thanks

msaltunsaray · 07-06-2019

Hi @Hector Gustavo Serrano Gutierrez Unfortunately I cant send any output as this is real network and because of company restrictions .But I can say that there is no mpls vpn so it is pure bgp and mpls. thanks

msaltunsaray · 07-05-2019

Hi @Hector Gustavo Serrano Gutierrez, I have a router which is connected to customer equipment via 1Gbps fiber. I have also pppoe with the customer to provide public IP and internet access. Typical fiber broadband access so far. On my router, when I ...

msaltunsaray · 05-02-2018

I have "template peer session IBGP" template peer-session IBGP remote-as XXX description IBGP Peerings update-source Loopback0 exit-peer-session ! If I write authentication under this template, would it be done for all my IBGP peers?

msaltunsaray · 05-02-2018

Is there a way to configure it under cluster instead configuring for each peering?

Member Since	‎11-07-2017 02:49 AM
Date Last Visited	‎09-18-2019 01:01 AM
Posts	11

User Statistics

User Activity

BGP Cluster Id

PPPoE over fiber broadband

Access-list for VTY line

BGP Authentication with two RR routers

OSPF BFD configuration on ASR 1002x

Re: BGP Cluster Id

Re: PPPoE over fiber broadband

Re: PPPoE over fiber broadband

Re: BGP Authentication with two RR routers

Re: BGP Authentication with two RR routers