About B@B@r

B@B@r · 02-25-2021

Dear all, I want to advertise 2/25 to our upstream providers Both have different ASN. I How can i set BGP attributes so that I can advertise 0/25 for one ISP and 128/25 for other ISP. Please note that our ISP advertise /24 rather than/25 to t...

B@B@r · 08-01-2018

dear Experts, I am studying Graceful shutdown of Eigrp. and found that this feature is enabled by default in Cisco. whenever we remove any network from topology it will automatically remove route rather than wait for hold-down time and send terminate...

B@B@r · 07-01-2018

hi all i am working on rip i want to break rip updates by denying 224.0.0.9 which is not working my configurion access-list 1 deny 224.0.0.9 0.0.0.0a access-list 1 permit any int fa0/0 ip access-group 1 in ip access-group 1 out but still, hav...

B@B@r · 06-08-2018

Dear all, i am going through mac access-list, while PERMIT the mac-adress of source host it is asking me 48-bit SOURCE MAC ADDRESS MASK. 1-what is concept of source mac-address mask? 2-we have difference host from different vendors like ci...

B@B@r · 05-30-2018

Hi every one. i am working on l3 ether-channels my topology is as under... as mentioned in above pictures... when is run command show etherchannel summary all the 3 switches show me RU ( R l3 and u In use) they are now showing me down then ...

B@B@r · 07-02-2018

Rip routes are still there if it is not working could i block at udp layer 520....

B@B@r · 07-02-2018

Dear bobby,yeah i used standard access-list, but after guidance of first reply i tried for extended access list still it is not working.i know about passive interface ,it stop sending routing updates i tried it is working perfactly...But i want to bl...

B@B@r · 07-02-2018

Thankyou for your reply,i tried it but still it is not working .rip is still learning route from neighbori also did clear ip route *show access-list 10110 deny ip any host 224.0.0.9 (312 matches)20 permit ip any any ( 12 matches)inter fa0/0ip access-...

B@B@r · 06-01-2018

i mean L3 it was mistype

B@B@r · 06-01-2018

Thankyou.ok one more question, In L2 etherchannel we use no switchport its mean its l3 port , there is no concept of vlan in l3 port,then why these ports are assigend to vlan 1006 to onward.command:show vlan internal usage

Member Since	‎11-08-2017 12:17 AM
Date Last Visited	‎03-21-2021 02:25 PM
Posts	38
Total Helpful Votes Received	5

User Statistics

User Activity

How to advertise 2 /25 as /24 to upstream provider through bgp

gracefull shutdown vs GR(gracefull restart) eigrp

rip 224.0.0.9 suppression not working

MAC Address Wildcard Mask | mac access list

L3 Etherchannel Problem

Re: rip 224.0.0.9 suppression not working

Re: rip 224.0.0.9 suppression not working

Re: rip 224.0.0.9 suppression not working

Re: L3 Etherchannel Problem

Re: L3 Etherchannel Problem