Hi everyone, In a new Cisco UC project, we have CUCM/Unity Connection/IMP/Expressway and CUAC standard. The pre-installed software for CUCM/CUC/IMP is on version 12.0 and they were up and running. The Attendant Console Standard was delivered via e-De...
Hi
We synchronized users from company AD and LDAP authentication is not enabled.
My question is what is the default password and PIN for these uses?
Thanks a lot!
Hi, This is my scenario,
There are two sites in our network with centralized CUCM deployment.
----HQ: 4 digits DN; DID number ranges: 8888XXXX----Site A: 3 digits DN; DID number ranges: 66660XXX
A CUBE is deployed in HQ providing the only SIP trunk t...
Hi,
I am configuring a CUCM 12.0 and trying to add a route pattern.
Just found that the "numbering plan" and "Discard digits" fields of the route pattern are grey out.
Is there anything to do with the Australian dial plan which I just installed. ...
We bought a BE6K system (CUCM+CUC) to replace the existing PBX. But there is no ISR router in the purchased list.
The existing PBX has a SIP trunk to the carrier.
I understand In Cisco preferred network architecture, ISR is required.
My question is...
