Hey guys,
To replicate the issue I'm having, all I need to do is change a registered Cisco 8841 phone's DN while it's registered and the phone will then become rejected. Once it's rejected, if I remove that phone's profile from CUCM and recreate it...
Hi all,
I require assistance (I have a ticket raised with Cisco but they're not returning any of my messages and it's been a few days). Whenever I add a new phone the registration ID becomes rejected straight away. The phone is assigned an IP but w...
Hi all,
I've pretty much sorted all of my main issues configuring Multicast Helper-Maps but there is one thing I'm having issues with.
I'm using the following config:
ACL:
ip access-list extended CISCO3000
permit udp any host 10.1.1.255 eq 3000
ip ...
Hello,
L2 2960X - Switch
L3 2921 - Router
This is the first time I've configured these using a L2 switch.
I have 2 remote sites that use very old applications that only use broadcasts. These remote sites need to be able to communicate thus the use ...
Hi all,
We're having issues at work configuring a 2921 with a 4 port EHWIC switch module and was hoping for some assistance.
Question 1) We can see the switchports on the router, and I've read we need to create a logical trunk on the backplane so...
So the issue has been resolved. I powered off our publisher/subscribers and booted them back up in sequance from publisher and than the subscribers. We had a power outage a week ago and ever since we've had these issues. I'm not sure if they need to ...
Hi Chris,
Much appreciate you help with this.
I've performed factory reset on these phones several times.
I have just lined 2 phones next to each other, one that is working and another that isn't working so I can compare the phone information.
Th...
Hello,
We're using Cisco CP-8841 phones.
I just took 2 brand new 8841's out of the box and connected them at my desk where my original 8841 was connected and they're getting rejected. The status messages on these phones all say the same thing and th...
