I had private server that i want to be accessed from outside. so i did all the Static NAT and ACL configs with default port 80.the issue is, once i typed the public ip from my browser which is behind the NAT, it displays the servers contents only for...
i have two ASA-5520's working in active active mode at the Edge of the LAN both working at a throughput of 300 Mbps. the problem i faced is that the CPU goes to 99% in peak hours and roughly over 50-60% in off peak hours. the ASA's are operating inde...
i used to have IOS issue with my 4506-Sup6-E Switch,i was able to recover it using a TFTP server but it still goes to ROMMON mode every time it reboots. i tried changing the cofig-register to 0x2102 but it can't take any effect either. Can you help ...
unfortunately that didn't work either,i tried that too. "%Port 8080 is being used by system min8080"is there any means that help me kill "system min8080"?
I actually tried that at first,but i shows this error and rejects my config"%Port 80 is being used by system min80"when i try to see my NAT config there was only one PAT/NAT-PT config with other public ip.
ip nat inside source static 192.168.1.144 1.2.3.4is the nat config,for the test purpose i did "permit ip any any" on both ACLs applied on ip nat outside and ip nat inside interfaces,which means not having an ACL at all. then what i did was http://1.2...
