About Zachary_Hamilton

Zachary_Hamilton · 05-21-2018

Hello, I have a UCS C240-M4 in the 12-drive form factor (RAID), as well as two drives attached to the first PCIe riser (SATA). I just got this out of the box so I haven't loaded or configured anything on it yet. I'm planning on installing Windows...

Zachary_Hamilton · 02-08-2018

Hello, I am comparing the configs of two 3850 switch stacks that I have. On one, the running config shows the following: no hw-switch switch 1 logging onboard counterno hw-switch switch 1 logging onboard environmenthw-switch switch 1 logging onb...

Zachary_Hamilton · 11-28-2017

Hello, I am trying to configure my IP Communicator, and frankly, I have no idea what I'm doing. I've managed to configure it far enough that it works for internal extensions, but not making external calls ("Your call cannot be completed as dialed"...

Zachary_Hamilton · 05-25-2018

Kirk, Thank you very much. From the Windows setup screen where it asks on what drive you want to install Windows Server 2016, it showed all 12 of the drives up front, but not the array (2 SATA drives) on the riser. At this point, I remapped the ...

Zachary_Hamilton · 05-25-2018

Hi Wes, I'm using CIMC to map a virtual DVD to the install ISO, and I'm then pointing to that as my boot device in the UEFI. Is that what you are referring to? I haven't been able to locate the driver ISO. I went here, but it didn't have the st...

Zachary_Hamilton · 05-25-2018

I actually made some progress... From the Cisco Integrated Management Controller interface, I went to Compute -> BIOS -> Configure BIOS -> Advanced -> LOM and PCIe Slots Configuration. PCH SATA Mode was set to AHCI, but I changed it to LSI SW RAID...

Zachary_Hamilton · 05-22-2018

Hi Kirk, I'm not seeing anything during POST about Ctrl+M. I can enter MegaRaid through Ctrl+R but I'm not seeing any of the settings you mentioned. But I'm a bit new to this chassis. :-) Are you saying that the MegaRAID configuration should sh...

Zachary_Hamilton · 11-29-2017

Rajan, Thanks. There was a CSS that was not set. If you or anyone else has any ideas about training or education, please let me know. Thanks, Zachary Hamilton

Member Since	‎11-28-2017 10:47 AM
Date Last Visited	‎08-08-2018 08:34 AM
Posts	8

User Statistics

User Activity

Can't see SATA drives on PCIe riser of UCS

hw-switch switch 1 logging onboard

IP Communicator and dialing out

Re: Can't see SATA drives on PCIe riser of UCS

Re: Can't see SATA drives on PCIe riser of UCS

Re: Can't see SATA drives on PCIe riser of UCS

Re: Can't see SATA drives on PCIe riser of UCS

Re: IP Communicator and dialing out