I have three cisco 3650 switches that lost power this morning.
Two booted as usual but one of them is stuck in a boot loop.
When connected via console I see this.
Booting...Interface GE 0 link down***ERROR: PHY link is downThe "IP_ADDR" en...
thanks again to everyone who tried to help.
Hoping this will help others.
Even after setting the switch in express setup to be able to get to the IOS again it was not possible to work on it.
In the end I had to replace the hardware.
thanks a lot for your input!
What you see is actually all that is happening on the switch.
Except there is another level I'm not aware of.
How would you do the recording you advised?