About michel

michel · 07-25-2021

Dear experts, I've setup a DVTI with IKEv2 to get remote access into my 2901. However, the IKE session establishes, without any errors, the interface comes up, but no IP address is assigned to the Virtual-access interface. The client is a C881 runnin...

michel · 06-20-2004

Hello there,I've been trying to get a Cisco VIC-2FXO-M2 to see the ANI. Now as I understand from the documentation I've read, what I am looking for is CLIP, and not CLID (Caller ID). This part is a little confusing to me.Below is the part that config...

michel · 01-13-2023

More to update -I redid the configuration on the router over the weekend to clean it up, and discovered that the settingservice-routing mdns-sdsource-interface Loopback0Caused the misbehaviour. It also triggered issues with my Ethernet interfaces not...

michel · 12-30-2021

After looking for a good while I stumbled across the solution yesterday. Apparently, ip unnumbered behaves differently if ipv6 is configured on the Loopback0 interface. I moved all IPv6 configuration to Loopback1 and have seen traffic flowing after t...

michel · 06-25-2004

Thanks for responding;The IOS releases I've tried this on are most of the 12.3 release train and a few in the 12.2T release train;According to a document here: http://www.cisco.com/en/US/products/sw/iosswrel/ps1835/products_configuration_guide_chapte...

Member Since	‎06-20-2004 07:12 AM
Date Last Visited	‎01-20-2023 06:23 AM
Posts	5
Total Helpful Votes Received	5

User Statistics

User Activity

DVTI no ip address?

Caller ID/CLIP on VIC-2FXO-M2

Re: DVTI no ip address?

Re: DVTI no ip address?

Re: Caller ID/CLIP on VIC-2FXO-M2