If we have stacked two or more cat9k and connect them is SD-Access fabric, then what will be the role of that Cat9K. Will it be displayed as a single node or multiple node?
Let's say, I have a CUCM server and 1000 voip capable cisco phone, all are connected in edge nodes.
How to achieve voice communication with Cisco IP phone. Where will be the placement of CUCM server and voice gateway?
Is there any refernece archi...
Not Required, I guess. By default it will install the image.Two type of Cisco Boot mode:Install Mode/Bundle Mode.Install mode is the default.Just change boot system flash:. Save the config and thenreload the switch.Note: Do not forget to check whethe...
What is the purpose of pushing changes from ISE to network devices? If I change anything anything in ISE, I use this button to push the changes to end devices.
The link is not reachable. However, I have upgraded stacked 9300 earlier. You need to1. download the IOS first from the Cisco. 2. Copy into a flash usb (FAT32 formatted)3. Plug it into 9300 switch front usb port4. Copy the image from USB to Flash-1 &...
This link is the best content as far Cisco gave publicly regarding DNA Center.
https://www.ciscolive.com/global/on-demand-library/?search=sd-access#/
Hope this helps.
Hi Mohammad,
Previously APIC-EM had EasyQoS functionality, which helped a lot. DNA Center, as Cisco says, with much more functionality. What happened to the EasyQoS?
Regards,
Manirul
