Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
assist check reachability
attached configs
R1#R1#ping 7.7.7.7 source 1.1.1.7 repeat 2Type escape sequence to abort.Sending 2, 100-byte ICMP Echos to 7.7.7.7, timeout is 2 seconds:Packet sent with a source address of 1.1.1.7 ..Success rate is 0 ...
hi people
cant reach my eigrp network from bgp
R1# sh run | se router eigrprouter eigrp 1 network 1.1.1.0 0.0.0.3 network 10.0.0.0R1#
R2#sh run | s router eigrprouter eigrp 1 ! address-family ipv4 vrf VPN_A autonomous-system 1 redistribute bgp 1...
R2#sh running-config Building configuration...
Current configuration : 1986 bytes!! Last configuration change at 14:51:33 UTC Wed Jan 17 2018!version 15.2no service timestamps debug uptimeno service timestamps log uptime!hostname R2!boot-start-marker...
If the network where XR1 is located is not injected into BGP, R1 is unlikely to learn about it. You may need to redistribute that network into BGP.done
