Utilizing ISE 3.1 and using the portals for CWA (centralized web auth).Does anybody know if it is possible to change the guest flow in the portal?
This is what I want to achieve:Default landing page should be the "self registration" page, not the "lo...
I am looking into enabling PMF on a dot1x WLAN, on a 9800 running v17.3.5bIs dot1x SHA2 mandatory for PMF to work or does PMF work with dot1x SHA1?
Found this guide that says SHA2 has to be enabled for PMF to be mandatory, but on the WLC I can set PM...
Does the 9300 EWC (embedded wireless controller on Catalyst 9300 switch) support gNMI as model-driven configuration management? Found this documentation, but it does not mention embedded wireless controller on switches.https://www.cisco.com/c/en/us/p...
I'm looking at high channel utilization issues in DNAC (v. 2.2.3.6) from an 9120i connected to a 9800 v.17.3.4cSeeing high channel utilization, low interference and low tx/rx utilization from the AP.
Is it correct that there is some other 802.11 devi...
I can see the client TX rate to AP, but is it possible to see what kind of TX rate AP has to the client?The accesspoint knows which rate it sends data at, so sounds like this should be able to be seen somewhere.
In Windows it is simple to see tx and ...
Maybe not. I found this script and trying to tweak it to make it work. https://community.cisco.com/t5/security-blogs/ise-guest-login-page-pre-fill-and-hide-password-field-single/ba-p/3658312
I saw that one, but when I test in my lab I get PMF to work, utilizing SHA1 as AKM. So that is when I scratched my head for why the config guide says SHA256 is mandatory for PMF to be mandatory.
