To accomplish this, you're going to need a switch and 2 800 routers. You will also want to use 2 vlans on the switch. Plug one ethernet interface from the 2 800 routers into the switch and the cable modem into the switch(outside net), and plug the ...
Choosing between NAT or Tunnelling will depend on what your requirements are for the LAN's to speak to each other. If you want your private IP's from one LAN to reach private IP's from another LAN without using an external address translation, then ...
Hi laceyis, The previous post is correct. There is not a dust cover for your switch. A cover would restrict the air flow and the switch would more than likely kill over. RJ-45 ends would be your best bet for covering the unused ports.Later,Erik
Hi b-byrne, You can remove your moh server from the moh server config within ccm admin. You could also set your moh audio source to none within your device pool config your phones are using. I hope this helps!Thanks,Erik