I'm not able see any data in the sntc portal. I get a System message as follows:"System MessageYou don't have access for this report, please request access" My access was working, not sure why its isn't anymore ? @cisco is something broken ?
CSPC ver 2.8.1.6 Using SNMP v2 to collect network information for Cisco ASR9K and 900 series routers Inventory has been uploaded to SNTC portal however i'm only seeing the devices in the inventory but not the cards/ modules etc.How can i get the car...
CSPC ver 2.8.1.4 I'm getting the following error at the upload phase: CSP0009043224: A connectivity exception occured while processing the request. The Exception is :: HTTPs TransportMode has Failed 404:Not Found See job report below: Phase NamePha...
Hi,I have a question regarding the following policer and shaper on the me3600 platform service instance:interface GigabitEthernet0/1 switchport trunk allowed vlan none switchport mode trunk mtu 9000 service instance 1 ethernet encapsulation default ...
I have a 2651XM-V router equipped with a MFT-E1 card and a AIM-VOICE-30 module.I would like to use this router at a central site connected to a PABX via the E1 and group the timeslots for different types for eg. i want the first 4 timelsots for E&M s...
Thanks for your help. I ran the collection profile (i think hadn't actually done that before). Now i can see in the collected data snmp information.And i've also ran the upload profile after that. I'll pm you the screenshots anyways to check.
Yes i have. Is there a particular dataset that needs to be added in the Collection profile ? Also I'm only using SNMP not ssh/cli . Does ssh need to be enabled ?
