I have attached the sample diagram here. I have 5 Cisco small business switches. The core switch (Port 28) is connected to the Plant switch with Fiber connection. Core is connected to the Firewall as Trunk port (1U, 20T, 30T). Port 26 on the Core ...
I have a core switch and Wifi Switch where Access Points are connected to Wifi Switch. This is how it has been configured.
Wifi VLAN 20
LAN - VLAN1
Port 27 Core - 1U, 20 T (Mode - Trunk Port)
Port 21 Core - 20 U ( Access Port)
Port 1 WIFI - 1U, 20T (...
We have Unifi APs which has 2 SSIDs (VLAN 20 and VLAN 30). Both SSID are tagged on AP.
There is no other settings on the AP. APs are getting DHCP address from Firewall.
Please let me know if you need more info.
Thanks for the response.The core switch is connected to the Firewall which provides the IP addresses for all VLANs (DHCP). The core switch is connected to the Wifi switch and APs connected to the this switch works fine.I had the same Trunk config bet...
As you explained here, I understand why AP did not get VLAN 1 IP address. I remembered I did this setting one time (Core Port 21 and WiFi (current) Port 14 as trunk (1U,20T)). I will try one more time and let you know.On core Port 27 which is connect...
Hi Antonion,You are right. This is the Layer 2 switch and there is no ACL configured on it. All the routing has been configured on the Firewall.Port 1 on the Wifi Switch is configured 1U, 20T which breaks no now another port is configured as 20U and ...
Vlan 1 is our management vlan. Now I am directly connected to the Cisco wifi switch as I could not access it from server but I am able to ping the server from wifi network but not pinging from server to wifiAny thoughts??