Hi, Greetings, Currently working out with Cisco IP Phone 8851 and 8832 however got stuck with this prompt message. Is there someone here who can help us to go through?
I'll be working to recover an administrator password of a switch specifically cisco sg 350 - 28 without any effect / changes in the other configuration. I've tried to consider a solution stating in the two (2) given link 1. https://community.cisco.co...
Greetings,
I have three Cisco Switch SG300-28 28-Port Gigabit Managed Switch and one Cisco Router 1841. I want to implement PVLAN on all switches for security purposes. I configured VLAN on all switches then set a trunk port for Router-on-Stick, so...
Hello Good day. I am configuring InterVLAN Router on Stick wherein I encountered unsuccessful pings. There are two switches connected to a one router. Each switch has three connected host. I think I'm having a problem with the network address since i...
Greetings,
I am currently creating a simple network design consists of Static Routing and Virtual Private Network. The tunnel between two routers works successful. Static Routing is configured on both sides however one router cannot reach the clien...
In our case, as per research, I've found out that it can't be possible to upgrade our devices into MPP firmware due to:Model of the device (CP-8851NR) is not eligible from Enterprise to MPP Firmware Migration.CP-8832NR can be migrated into MPP but so...
@Roger Kallberg, ahahahahaha, I thought the term is something related to Cisco or any other network related concepts, I'm searching for it but can't find an appropriate match. Anyway, thanks so much for your insights, it is greatly appreciated.
Hi Sir @Jaime Valencia, What if the plan is not to use a CUCM/CME but will integrate into other that uses SIP protocol, will that be possible? Is the phone still be able to use or am I going to upgrade the firmware for it to be integrated?
