Hello,
I am getting IPFM requirement, but I am searching for document to learn why we need IPFM in the first place?
Why IPFM? Why not Cisco ACI? Why not our legacy switches platforms like 2960, 3560 etc.? I mean, why IPFM invented as we already have...
for icmp, there are no flags in ASA under show conn outputs, but i observed one thing that if i ping from source (inside) to outside then i can see inside 10.1.1.10:5 (:9) always incrementing whenever we initate ping and destination ip:0 is alwa...
hello,
i am unable to ping from R7 to R3 and vice a versa
please help why nssa to nssa is not pinging
i configured default-info originate always command but still i cannot find default route in route table nor i am able to ping loopback ip.
Hello Friends,
after many tries, vedges showing unreachable after adding into template.
without template individual one by one vedge showing in sync under configuration - devices
when i add into template to push other configs through template, vedge ...
Hello,
first two vEdges were onboarded manually by setting up Ip addresses unde vpn 0
third vEdge, i am trying to onboard using prebuilt templates but under vmanage-confg-devices, its showing synch pending, device is offline
what could be an issue ?
Hello Dawei,
thank you
to learn IPFM deployment, how to connect endpoint to IPFM network? what configuration required for endpoint ? does it require routing in IPFM ? or switching only ?
i mean, when we say IPFM, its all about endpoints connectiv...
Hello,
can you please let me know why we need these IPFM solution? why we need 2 tier clause architecture as we have Cisco ACI solution in place? why we need this solution?
like if we see UIOB that means outside to inside and without B UIO inside to outside, we can identify from which direction traffic initiated but for ICMP we dont see any flags so can we conclude as per above message ?
Hello MHM,
i configured default info originate always under router ospf 1 on R1 and R5 (ABR)
i configured area 2 nssa default info originate command on R6 and R4 (ASBR)
but still i cannot see default route in nssa areas therefore i cannot reach R3 ...
Hello MHM,
I need to configure default originate on IOU2 and IOU5 as per above and see if default route getting generated or not...
Thx MHM I will come back today EOD
