About Aws Al-Dabbagh

Aws Al-Dabbagh · 11-14-2019

hi all,IP Telephony and Phones, Unified Communications I have a CME with several IP PhonesI installed a 3CX server for a small team to make outgoing calls. I need to add a SIP trunk between the systems to allow CME users to call 3CX users, as well as...

Aws Al-Dabbagh · 12-01-2019

thanks for all the replies: the latest update is: 3CX--> CME is workingCME-->3CX getting busy tone no logs on "debug ccsip message" nor on "debug ccsip non-call" 3CX keeps sending SIP error "407 Proxy authentication required" for any call INVITE sent...

Aws Al-Dabbagh · 11-25-2019

@wkyuen.ricky1 wrote:Did you see any debug log when making calls from 3CX to CME? debug voice ccapi inoutthanks for replying. no output on this debug command when making or receiving calls. I'm getting the messages by running tcpdump (set to UDP) on...

Aws Al-Dabbagh · 11-24-2019

OK guys.I got the bridge Trunk up. now I'm calling 3CX-->CME again. but CME-->3CX gets a busy tone with "407 Proxy Authentication Required". how do I send this Proxy Authentication from the CME?error packet and CME config below: User Datagram Protoco...

Aws Al-Dabbagh · 11-21-2019

thanks for the help so far. after a few days of trying, I got to this config:!dial-peer voice 101 voipdescription for incoming calls from 3CXsession protocol sipv2session target ipv4:10.10.30.26!dial-peer voice 102 voipdescription for outgoing calls ...

Member Since	‎02-07-2018 07:52 AM
Date Last Visited	‎12-04-2019 12:49 AM
Posts	5

User Statistics

User Activity

SIP trunk from CME to 3CX

Re: SIP trunk from CME to 3CX - Proxy Authentication

Re: SIP trunk from CME to 3CX - Proxy Authentication

Re: SIP trunk from CME to 3CX - Proxy Authentication

Re: SIP trunk from CME to 3CX