Hi
I am having an issue with an ASA 5512. It will randomly lock up and from the point on no traffic passes through. The only way to access it at that point is to access via console. When trying to access via SSH we get the banner login and are able...
Over the last week we have been experiencing problems with our ASA 5512. The Firewall has went down 3 times over the past week with no knowledge a to why. In an attempt to diagnose the problem I configured syslog (PRTG) and setup debugging. The devic...
Hi
I have been trying to setup SNMPv3 on our local ASA. The idea was to monitor traffic through the use of PRTG.
As far as I am aware I have created the user, group, created a network object and allowed SNMP and SNMP traps on the ASA through an e...
Okay. Firstly. Noob manoeuvre (Wireless isn't my area of expertise) on my behalf, I purchased a lightweight AP from the A regulatory domain when it should have been the E regulatory domain. These were cheap AP's but rather than throwing in the towel ...
Hi
Have you used the free PRTG SNMP tester? It helped me out a lot especially when implementing SNMPv3.
https://www.paessler.com/tools/snmptester
You can use it for the purposes of testing SNMPv2 and SNMPv3. It's what helped me out when trying ...
Hi Rahul
I had noticed this last weekend: https://bst.cloudapps.cisco.com/bugsearch/bug/CSCva80364
I lowered to level 3 and below. The same problem happened. Internet connectivity lost and remote management lost. I then turned off syslog and the ...
Thanks. This would make sense. It was the syslog that would go down before the Firewall device ground to a halt completely, with no flow of traffic. I updated it on Saturday afternoon to the latest version and so far so good. Debugging has also been ...
Thanks Karsten
This was indeed the answer. PRTG only works with 128 AES or below or DES.
Sorry for the late response and thanks again for the knowledge.
