Hi All,
Can you please help me with the below issue:
Smart Software Manager Satellite Version 5.0.1 HA is not accepting FQDN, trying to configure HA on F5 GTM.
Please check the attachment to get clarity on the configurations.
Followed the bel...
Hi All,
Good Day
I would need some assistance on checking the DX80 latest firmware compatibility for CUCM 10.5.2.
I would need to perform the firmware upgrade for DX80 device.
CUCM version - 10.5.2SU4
And i can see the latest firmware avail...
Hi All,
We would like to setup a syslog server for the Cisco gateway devices, for collecting the logs.
Have a query on this , whether we can use FreeFTPD software as a syslog server?
Or there only the recommended software to setup the same.
Sinc...
Hi All,
We have recently upgraded our Call Manager to 12.0.1.219, and now when I try to add a VG204XM gateway I receive the following error when I try to configure the FXO ports:
"
Access to the requested resource has been denied, The attempted a...
Hi All,
Could anyone please help me with the below query on the following Windows and Linux servers:
Cisco Unified Call Manager 10.5.2.10000-5 Virtual Appliance
Cisco Unity Connection Version 10.5.2.10000-5 Virtual Appliance
Cisco Contact Center ...
Hi Balaji,
Thanks for your response . Appreciate the same.
Here I am using windows machine as syslog server,
But wanted to know if I can use the Freeftdp /tftp software for collecting the logs /is it supported , or we should use only specific s...
Good day. Noted with thanks for Jaime and Chris. I supposed the commands is also applicable on virtual appliance (not UCS) & our versions below.CUCM 10.5 / CUC 10.5/ UCCX 10.6Disable secondary nic, run "set network failover enable", enable secondary ...
