Hello Mohanvenkatram,
Configuring MAC address for specific port
Layer 2 is the Data-Link Layer. Devices operating at Layer 2 sort packets using physical network addresses, also known as MAC addresses. All network hardware is permanently assigned this...
Hello Sathiyamoorth,
Transport preferred Transport preferred command is used to specify which transport protocol is used on connections whereas the transport input and transport output commands are used to explicitly specify the protocols allowed on ...
Hello Yogesh,
cisco 2960 to HP procurve switch communication
2960 won't accept the command "switchport trunk encapsulation dot1q" because their default is already dot1q
When connecting trunk port to the client you need to also use the commands sto...
Hello Carlos Andres,
QoS configuration for Application The link below contains certains examples where there are examples in which QOS is configured for catalyst switches.
However without knowing the exact scenario , it's difficult to give the exact ...
