Buy or Renew
Buy or Renew
amcsystemstech
Level 1
Level 1
Member since ‎08-06-2004
‎08-18-2017
Recent Badges

User Statistics

  • 19 Posts
  • 0 Solutions
  • 21 Helpful votes Given
  • 0 Helpful votes Received
Recent Badges
See all
5 Discussion Posts
10 Discussion Posts
10 Replies
5 Replies

User Activity

Bridged point to point T1 setup questions.

08-21-2006
One of our locations is adding a small five user office to its business. They are going to connect the remote office via point to point T1. I've decided to use bridging to lessen the impact on the rest of our network.I have a test setup up and work...

A reliable place to get a WIC-1DSU-T1 interface card?

08-16-2006
Anyone know of a reliable place to get a WIC-1DSU-T1 interface card. I need the first generation version of this card not version two (-v2). I found several for sale on the net, but I'm short on time and don't know much about the vendors. If anyon...

Troubleshooting T1

06-07-2006
I have a point to point T1 that is acting up. Both sites are using Cisco 1721 wih T1 CSU/DSU wic cards. This T1 link has been running fine for about two years. Two weeks ago, the remote site started complaining of speed issues. Upon investigation...

Cisco 2600 modifying controller T1 0/0

05-09-2006
Our provider is upgrading our frame relay ciruits. So I need to modify a Cisco 2600 to work with the new speeds. I've done such configuration on Cisco 172X routers, but never the 2600.Most of the 2600's config is familiar. One major difference is ...

eigrp and interface address change

01-19-2006
I just want to make sure I'm doing this correctly. If you change the IP address of a router using eigrp. Assuming the partial config below, Would these be the commands to modify the router? Thank you for your time.router(config)# interface Etherne...
View more
Community Statistics
Member Since ‎08-06-2004 07:17 AM
Date Last Visited ‎08-18-2017 03:51 AM
Posts 19