Hi,I have a 2801, no special configuration beside an WAN ACL , NAT and also FW on the output interface. My setup works fine, the only issue is the bandwith.On the WAN side I can downnload with full speed (around 4Mb/s), on the inside interface with o...

Hi all,We have some troubles with Remote office connection when using an specific ISP. This ISP his off course not singled-homed and has Reverse Path Forwarding enabled. I know that provisions for asymmetrical flows (when outbound traffic goes out on...

Hi all,I'm having a strange issue, maybe someone can help me out.I have a 2801 router with 3 interfaces (inside, outside , DMZ) when i configure ip inspect, i can't use www from inside to outside. the strange thing is that i can still ping an outside...

Hi,I upgraded my PIX to ver 6.3.(4), PDM to 3.0 and now PDM doesn't support the alias command. It tells me to replace the alias command with outside NAT...The reason I used alias was to replace the destination address for some traffic going from insi...

Hi,I count one your expereience to find out where this errors are coming from:FastEthernet41 is up, line protocol is up Hardware is epif_port, address is 0005.32fb.412f (bia 0005.32fb.412f) MTU 1500 bytes, BW 100000 Kbit, DLY 100 usec, rely 253/255...