Hello everyone,i have 2 ASA5520,configured Active/Standby.on the primary unit, it has 3 interfaces configured and connected(outside, inside--g0/1.200 and one more Lan interface)so whenever we connect the secondary ASA, the Inside port shuts down by i...
hi everyone,
i have an issue, i have list of rogues that are in "unclassified rogue". when i classify any of them to "malicious" and "state: alert". it will go to "malicious rogues". but after sometime again it goes back to "unclassified rogues". can...
hi everyone,
can anyone help me in below configuration.
i want to prioritize my network, switch has to pick 1st priority as internal lan. following are the priorities. can anybody explain this.
Priority 1: LAN (10.x.x.x)
Priority 2: network2- vlan2 ...
hi Salim,1) cannot able to ping the 10.253.0.2 from 10.253.0.12) i can see the mac address of the primary ASA. but I cannot see the mac address of secondary ASA.3) yes vlan 200 exist on all the switches. 4) Attached show monitor-interface output5) Ou...
the interface is a trunk and not configured any port-security. but still, used shutdown and no shutdown commands. still, it's the same. this event happened long back. so, no recorded event for this issue on the switch.
