Hi all
I am trying to configure L2VPN VLAN based on uBR7225VRX running ubr7200p-jk9su2-mz.122-33.SCG7.bin but without success
Following the official Cisco doc:
https://www.cisco.com/c/en/us/td/docs/cable/cmts/config_guide/b_cisco_cmts_layer_2_vpn...
Solution was found.
It is enough to enable TLS next way:
cable l2-vpn-service xconnect nsi dot1q interface GigabitEthernet0/3
So all packets from CM with CF that contains L2VPN parameters will be transferred to g0/3.
It is not under CMTS responsi...