davec4351
Level 1
Level 1
Member since ‎03-27-2018
‎06-22-2022

User Statistics

  • 40 Posts
  • 2 Solutions
  • 5 Helpful votes Given
  • 15 Helpful votes Received
Recent Badges
10 Helpful Vote
1 Helpful Vote
20 Replies
10 Replies
5 Replies
1 Accepted Solution

User Activity

Hello, I have a router configured on my lan, the source interface is gi0/0/0 and ip is obtained with via dhcp. My question is can I configure an acl without specifying the wan interface ip since the dhcp address changes every so often?  Here is a sni...
Hello, I have an interesting issue with my sip provider. I received the MWI status in the debug messages, however my phones do not light up for MWI. I have a stripped down configuration attached. I have heard its related to codecs, but I have my code...
ICNISR4k#show versionCisco IOS XE Software, Version 16.12.03Cisco IOS Software [Gibraltar], ISR Software (X86_64_LINUX_IOSD-UNIVERSALK9-M), Version 16.12.3, RELEASE SOFTWARE (fc5) I can run this command for a 8845 sip phone#show voice register pool 1...
Hi, I have a 3702i repeater configured autonomous and I am able to connect to it, but it seems that using a laptop or phone does not get out to the internet. From the repeater I can connect to the internet. If I set up the dot1 radio as a workgroup b...
I have a few interfaces on my router one of which I want to use a cellular interface as a backup. I am having trouble with the routing for my internal lan out to the cellular interface, though I am able to do a route statement 8.8.8.8 255.255.255.255...
Community Statistics
Member Since ‎03-27-2018 12:05 PM
Date Last Visited ‎06-22-2022 12:08 AM
Posts 40
Total Helpful Votes Received 15
Helpful Votes From
Helpful Votes Given To