About Maurice_

Maurice_ · 03-30-2023

Firmware 10.4.2.0 for CBW150AX / CBW151AXM has been released, but I can't find the release notes anywhere. Can someone provide a link?ThanksMaurice

Maurice_ · 01-28-2023

Hello,Does the 150AX support WPA3-OWE (Enhanced Open)? It's essentially an 9105AXI (ap1g8) with a modified version of EWC, correct? The 9105AXI does support OWE, but I can't find anything about the 150AX.We currently use 1815i APs with Mobility Expre...

Maurice_ · 07-03-2021

I'm trying to connect an HP Laser 107w printer to an Aironet 1815i AP. The AP is running latest Mobility Express Firmware 8.10.151.0. The WLAN is configured with basic settings (WPA2 PSK). The printer won't connect. Other devices have no issues conne...

Maurice_ · 05-18-2019

I'm using the Cisco Wireless Android app to monitor a Mobility Express system. This worked fine with all ME versions up to 8.8.111.0.After updating ME to 8.8.120.0 the app won't connect any more. Error message: "Please enter valid credentials."The cr...

Maurice_ · 12-07-2018

I use a WPA2-PSK SSID for IoT devices which don't support 802.1X. Now some of those devices need to be moved to a separate VLAN. Can this be done with Mobility Express (8.8.100.0) without creating yet another SSID? I'm thinking about MAC-to-VLAN mapp...

Maurice_ · 06-21-2023

The CBW APs only require a DHCP server for initial setup. After that, you can configure static IP addresses. Be aware that you have to configure two static IP addresses: One for the AP and one for the embedded controller ("primary AP"). If you only c...

Maurice_ · 06-21-2023

You have to change the native VLAN ID on the CBW150AX to something other than 1 (Wireless Settings / Access Points / Global AP Configuration). Whatever VLAN ID is configured there will never get tagged, even if configured otherwise in a WLAN.I did ch...

Maurice_ · 05-15-2023

The management traffic of these APs is never tagged. You need to configure your desired management VLAN ID as native on both the switch port and the AP (Wireless Settings / Access Points / Global AP Configuration).

Maurice_ · 05-14-2023

Did you check whether the mesh extender's MAC address was added to the local MAC addresses allowlist on the primary AP? You might have to do this manually.

Maurice_ · 05-13-2023

You can't change the Operating Mode, you have to change the AP Role. Take a closer look at the screenshots in the article you linked to.

Member Since	‎04-02-2018 10:01 AM
Date Last Visited	‎11-22-2023 12:57 PM
Posts	60
Total Helpful Votes Received	24

User Statistics

User Activity

CBW150AX 10.4.2.0 Release Notes

WPA3-OWE supported by 150AX?

HP laser printer fails to connect to Aironet 1815i AP (ME)

Cisco Wireless Android app won't connect to ME > 8.8.111.0

ME: MAC address to VLAN mapping

Re: need a replacement for wap150

Re: CBW150AX VLAN tagging does not work for VLAN 1

Re: CB150-AX VLAN question

Re: Cisco Business Wireless 140AC Access Point cannot change to mesh m

Re: Cisco Business Wireless 140AC Access Point cannot change to mesh m