About vtnd09876

vtnd09876 · 03-25-2015

Integrating ICM Script with 3rd party VRU using GED-125 interface. I am having trouble to send the call from Cisco CM to 3rd party VRU. Trying Send to VRU node but it is not clear how to pass the destination for 3rd party VRU.Any feedback would be he...

vtnd09876 · 04-03-2015

Actually, I was able to send the call from ICM script to 3rd party VRU using Send-to-VRU node.I am still using type 10 Network VRU as this seems to be the go-forward option.Thanks a lot for your help.

vtnd09876 · 04-01-2015

Good news is that I got Translation Route working - call gets routed to 3rd party IVR.Bad news is that I got various errors in rtr log such as:12:41:07:557 ra-rtr Target Val_PG5_1.SVC1(ID 5061) was ignored as no routes were configured for translation...

vtnd09876 · 04-01-2015

Hmmm, I was actually using type 10 in the above printout. But I was certainly confusing Service, TrunkGroup, and label between CUCM and VRU PIMs.Seems that Service, TrunkGroup, and Translation Route is configured properly now with label in Translatio...

vtnd09876 · 03-31-2015

The main part I am confused about is on PG there are currently two PIMs - CUCM PIM and VRU PIM. When creating Translation Route, should it be done on CUCM PIM or on VRU PIM? Also, it looks like for Translation Route, I need to create a Service, then ...

vtnd09876 · 03-26-2015

Well, according to all Cisco documents Send-to-VRU could be used with at least VRU types 3 and 7. I was trying to use type 7.The main problem I see is that there is no place to specify the destination for the call transfer. At least it is not obvious...

Member Since	‎03-25-2015 10:01 AM
Date Last Visited	‎08-18-2017 03:51 AM
Posts	12

User Statistics

User Activity

Sending call to 3rd party VRU from ICM Script

Actually, I was able to send

Ok. Something is not right

Hmmm, I was actually using

The main part I am confused

Well, according to all Cisco