About naveen230

naveen230 · 04-02-2018

I have a cisco 800 series router and its connected to a subnet (10.2.1.XXX local network address) and is connected to the Internet.How can I configure the LAN interfaces(FE0 to FE3) to be able to connect to the internet?Now I'm able to assign a 192.1...

naveen230 · 04-04-2018

Hello the following configuration worked for me.Thanks for the support you guys. Router#sh runBuilding configuration... Current configuration : 1557 bytes!! Last configuration change at 15:10:48 UTC Wed Apr 4 2018!version 15.5service timestamps deb...

naveen230 · 04-04-2018

10.2.1.1 is the gateway already used Can I use the same for this router bacause FE4 has IP address 10.2.1.74 and when I configure interface Vlan1 ip address 10.2.1.1 255.255.255.0 I get IP address conflicts!

naveen230 · 04-03-2018

All devices connected to internet have 10.2.x.x address because its a private network.And i'm able to ping 8.8.8.8 on the router and its successful.But on the device connected to router through FE0 to FE3 not able to ping google.com. yes 10.2.1.1 ...

naveen230 · 04-03-2018

Thanks for the suggestion, I followed the instructions but still devices connected to FE0-FE3 not connected to Internet.Is it because the router is connected to private network(10.2..x.x addresses) and its not possible to route? (asked in other for...

naveen230 · 04-03-2018

Thanks for the reply followed your instructions and got Router(config)#interface FastEthernet0Router(config-if)#ip nat inside ^% Invalid input detected at '^' marker.

Member Since	‎04-02-2018 02:30 PM
Date Last Visited	‎05-09-2018 09:15 AM
Posts	10

User Statistics

User Activity

Cisco 881 router in a subnet

Re: Cisco 881 router in a subnet

Re: Cisco 881 router in a subnet

Re: Cisco 881 router in a subnet

Re: Cisco 881 router in a subnet

Re: Cisco 881 router in a subnet