About martyn_jeffrey

martyn_jeffrey · 12-07-2014

Hi Guysi was hoping someone could give me a pointer on a Vlan setup issue i am having.EnviromentCisco S300-10 Switch (set to L3 Mode)I have uploaded a newb drawing of my switch config in the hope it may helpFrom My Office Pc i see the following sympt...

martyn_jeffrey · 12-10-2014

Hi Mate yes it has multiple. 2 for guest traffic2 for iscsi traffic2 for management

martyn_jeffrey · 12-09-2014

Hi MateThe Esx host can ping the office on Vmk0 ~ # vmkping -I vmk0 192.168.0.3PING 192.168.0.3 (192.168.0.3): 56 data bytes64 bytes from 192.168.0.3: icmp_seq=0 ttl=128 time=1.737 ms64 bytes from 192.168.0.3: icmp_seq=1 ttl=128 time=3.200 ms64 bytes...

martyn_jeffrey · 12-08-2014

IPv4 Route Table===========================================================================Active Routes:Network Destination Netmask Gateway Interface Metric 0.0.0.0 0.0.0.0 192.168.0.1 192.168.0.3 ...

martyn_jeffrey · 12-08-2014

Hey Phibertron No unfortunatly not, not from the office pc but i can from the switch and from inside the 192.168.1.x network

martyn_jeffrey · 12-08-2014

Hi i do have routes on my router to the other subnetshowever i had them setup as 10.0.0.0 sn 255.255.255.0 gw 10.0.0.1 (as i thought that gw would be the vlan ip)192.168.1.0 sn 255.255.255.0 gw 192.168.1.1 (again as i thought the gateway would be the...

Member Since	‎12-06-2014 12:27 PM
Date Last Visited	‎08-18-2017 03:50 AM
Posts	7

User Statistics

User Activity

SG300 Vlanning Issue

Hi Mate yes it has multiple.

Hi MateThe Esx host can ping

IPv4 Route Table=============

Hey Phibertron No

Hi i do have routes on my