you can use timer start command, after time expire you can close call.timer start named_timer 60 tim...

You can use above play_message_2_calling_then_connect.tcl file with below config for your case, plea...

If you are looking for specific Fax script you can download it from below link else you can use abov...

You are trying to collect digits after media is completed, try as below in act_setup procedure media...

Could you please explain more detail about your issue.Thanks,Raghavendra

When called party decide to transfer call then the TCL script should get "ev_transfer_request" event...

You can download the H450 script from below CCO location.Cisco SystemsThanks,Raghavendra

If you are using same PRI then no need of trunk group.To use TBCT, the following conditions must be ...

Since you have set CallInfo mode in TCL script, you don't need IOS config for this.You need to confi...

There are REDIRECT_AT_ALERT and REDIRECT_AT_CONNECT, commonly used for TBCT.REDIRECT_AT_ALERT -- if ...

Hi John,Please let us know what issue your facing with welcome prompt. You can raise Dev Net support...

from the link you shared below dial peer need to be changed, since In script "set param1(dialPlan) t...

looks like dial-peer config issue, if you press 0 also the dialpeer is matching. is it possible to c...

Please try to reduce timeout value under voice port and see.for example:voice-port 0/0/0 timeouts in...

Thanks for sharing logs, those are incomplete logs. please collect again with below debugs.undebug a...