netopia
Level 1
Level 1
Member since ‎10-19-2007
‎02-19-2019

User Statistics

  • 34 Posts
  • 0 Solutions
  • 14 Helpful votes Given
  • 10 Helpful votes Received
Recent Badges
1 Helpful Vote
10 Helpful Vote
10 Replies
5 Replies

User Activity

I have recently configured an ISR 4321 to act as a PPPoE server.  I have moved the configuration wholesale over from my old 1941 router.  Clients now are able to authenticate and get a PPPoE address, but are unable to reach the gateway, or indeed, an...
In our network we're settting up a large number of subinterfaces each with IPv4 & IPv6 DHCP, and with a distributed prefix pool for each IPv6 pool. I attempted to do this on a Cisco 1941/K9 running 15.1(4)M4 with the datak9 license enabled, and 200 ...
I've been experimenting with 6rd tunnels. Using a template I got from somewhere, I configured the following tunnel. interface Tunnel1001 no ip address no ip redirects ipv6 address 2001:1001:666F:726D::1/60 tunnel source GigabitEthernet0/1.1001 tunn...
I have a (non-cisco) device which requires a separate vlan for every downstream port, and thus multiple vlans upstream.  I'd like to find a way to bridge these vlans either at the switch or router level, so as to connect them to a single logical inte...
I have a 3750G switch (IOS 12.2).  I've got a server on a port off of this switch that sends out multicast traffic, but does not apply any QoS settings.  I'm trying to figure out how to add CoS or DSCP to all inbound traffic on the port (which is on ...
Community Statistics
Member Since ‎10-19-2007 11:03 AM
Date Last Visited ‎02-19-2019 10:22 AM
Posts 34
Total Helpful Votes Received 10
Helpful Votes From
Helpful Votes Given To