Hello,in an UCM 10.x environment with 7800 ip phones the user can add up to 99 speed dial destinations in User self portal. But just 6 of these 99 speed dial entries appears on the phone screen if the user press the navigation pad down.Where are the ...
Hi,i'm more tehn confused about the UCM Virtualizing. All Tools (CCW, Netformix) told me, the VMW-UC-STD-K9-1A is EoL, no replacement products are offered on CCO. I Ordered C200M2-VCS and need some Licenses. What i have to order?regardsRonny
Hi,i use a Gateway with ISDN and MGCP Fallback. In SRST mode all SCCP Phone are registered and in/-outbound calls working fine. The 9951 SIP Phones are also registering, but the incoming calls are disconnected with:SIP/2.0 406 Not AcceptableDid someb...
Hi,we have several ISDN BRI Carrier in Europe and the the same Appearance (Only BRI).MGCP from Gateway to Callmanager. Only "switch-type basic-qsig" works and the Port will come up to "Multible frames Established". In MGCP Normal Mode all works fine....
Hi,i want NAT from outside to inside. This works fine so the inside Station (Web-Server) have an Default-Gateway to my NAT-Routers inside Interface-IP.I want NAT from Outside-IP 213.1.1.1 to Inside-Station 192.168.235.56 and the originator-IP should ...
Hi Sandeep,i've got the same Topic.Did this work with loacl-proxy-arp?Do you can support me with an config template for ip nat outside pool...this would excellentregardsRonny
No, i used a Com-Port (it's tested) and the Cisco console cable. That's not the Problem. I configured this Router over this line before and was set the Boot index.regardsRonny
