Hi Alexandar, I have a question about a LAC ASR9K in a LAC/LNS scenario.Assuming that MSS is set in the LNS side, do we need to add the "l2tp tcp-mss-adjust" command to the ASR9K LAC as well?Thanks and Regards,Dimitris
Hi Xander,Hope you are doing good!I have a question, not related to load-balancing but to LAG and since I couldn't find any other relevant document I decided to ask you here :) . It seems it is not allowed to configure the bandwidth command to physic...
Hey Xander,
Quick as always :) Thanks!
So, if I am not mistaken, we don't expect any scaling issues in the following setup, even if we apply the policy to all 64K sessions, right?
2 x A9K-RSP440-SE1 x A9K-MOD80-SE64K LC DS PPPoE sessions
policy-m...
Hi Aleksandar, Xander,
Hope you are both doing fine!
I would like to ask you if the scalability charts are somehow affected if we enable egress queueing in a part of the sessions.
To be more specific, we are interested in LC (MOD80-SE) based dual...
Hi Cristian,
Although your question is quite old and you may have found a solution, I will describe what we are doing, although it is not 100% dynamic.
LAC config
vpdn-template VPDN-SETTINGS dsl-line-info-forwarding
RADIUS config
cisco-avpair="vp...
