About eric nguyen

eric nguyen · 10-21-2014

So I have RMAd 3 ASAs with the same problem and the replacements seem to be doing good. Everytime I ...

eric nguyen · 09-12-2014

I have 13 sites each with an ASA 5505 and a Cisco 1602i directly connected to ethernet 0/7 via short...

eric nguyen · 09-09-2014

Thanks for the assistance and I have tried looking into IP-SLA, but I can't figure out how the local...

eric nguyen · 09-09-2014

Yes, all your assumptions are correct. Question on this:ip route 10.2.3.0 255.255.0.0 166.139.144.15...

eric nguyen · 09-09-2014

I have attached a diagram and running configs.Basically, I'm not sure how the IP-SLA would work with...

eric nguyen · 09-06-2014

I have two 2901's currently connected with a site-to-site T1 connection. The company is looking at u...

eric nguyen · 05-07-2014

I have not done a packet capture yet.Yes, the PCs have the correct default gateway, they all point t...

eric nguyen · 05-07-2014

I have an issue that's been bugging me since this morning. This site has a single VLAN, 1, and the g...

eric nguyen · 02-10-2014

This has been resolved. Turns out the device said it could support WPA2-PSK using AES and TKIP, but ...

eric nguyen · 02-07-2014

I'm dealing with an Oxinet III device which has a Gigabyte GN-WI01GS wireless card in it. The device...

eric nguyen · 01-09-2014

I have 6504 connected to an Enterasys N3 that I cannot manage and the guys that do aren't very helpf...

eric nguyen · 03-20-2012

A few weeks ago we migrated from MGCP controlled CMMs to SIP controlled 3925's. The call flow goes A...

eric nguyen · 07-01-2011

We have a root AP whose status light is showing solid red. We power cycled it and it still shows sol...

eric nguyen · 05-03-2011

Well, we're a Cisco partner so we have some pull with our SE's. According to one of the high level e...

eric nguyen · 04-25-2011

Well, from where I insert the CF card, there's an "Assy #" sticker, a "Serial #" sticker, and a "MAC...

So I have RMAd 3 ASAs with