I need to execute a command periodically, using EEM. To test it, I just want to turn off and interface periodically each 1 second. To do it, I did the following:event manager applet BKPevent timer watchdog time 1000action 1.0 cli command "enable"acti...
Hello,I have a network which the topology is similar to the following:In the topology there are two tunnels with ISAKMP and IPSec configured between the Client router and the Prov router.The client asked me to configure ZBFW in the MID router, with t...
Hello,I'm trying to do a tunnel between two routers, where the objective is communicating their loopbacks. Both loopbacks use IPv6, and both tunnels use EIGRP to communicate their loopbacks. When I finished it, both tunnels could talk each other if t...
Hello, I am studying for CCNA R&S and I have a question that I cannot find the answer: I am reading the possible situations from show interfaces command line. And I read that if you have the situation Line Status Up and Protocol Status Down, it means...
Hello Georg,After a couple of tests in the client's lab, I could configure ZBFW with the idea of letting pass SSH, TCP, UDP or ICMP traffic from the client's side to the Prov side, with the condition that the tunnel configured between the Client rout...
Hello, I have used a simulator to show how is the topology, but for this solution I am using a Cisco 4321 as the MID router. Thank you for your support,Franco Riggio
Excuse me, but I have solved it. The problem was that at first EIGRP processes could not talk to each other because I did not write the command tunnel mode ipv6ip. But after doing some tests, I reloaded the routers and it worked! I share you what I d...
Thank you Paul.I'm sorry, but I haven't found any information about it except that the maxium number of helper-address in an interface can be different depending on the router's model
Georg, I have activated CBAC in the router and when I do it the router writes automatically a configuration. But when it applies the new configuration, it shows an invalid input. This is a part of the console:
ip inspect udp idle-time 1800 ^% Inv...
