About bej

bej · 02-23-2005

Under policy-map and class i cannot get the set command listed. I want to use the "set" command to set the dscp field. Is there anything besides cef that has to be enabled ? Router(config)#policy-map BetaRouter(config-pmap)#class ARouter(config-pmap-...

bej · 02-22-2005

Under policy-map and class i cannot get the set command listed. I want to use the "set" command to set the dscp value. Any suggestions ?

bej · 01-30-2005

I want to know if it is possible to disable OSPF downward bit propagation. The PE router will set the downward bit when flooding LSA's from other sites to the hub router and as they pass through the spoke router and back to the PE-router the PE rout...

bej · 01-05-2005

This is my problem :I have one management site and 3 other sites, site A,B and C. The management site is represented by one VRF and is located on the router(made up of 3 loopback addresses, no physical interfaces, the site is located on one of the ro...

bej · 11-22-2004

I have the following problem: I cannot ping either of the CE router int. from the PE routers but i can ping the PE router interfaces from CE router. Interface status(PE to CE) on each of the PE routers is UP/UP.The problem seem to caused by this inte...

bej · 02-23-2005

OK, that made it clear to me. I can use the rate-limit (CAR) statement used with access lists on an interface to set value for the dscp field in the ip header. This will give the same functionality as CB marking. Thanks.

bej · 01-06-2005

Thank you. Is it possible to specify source interface when doing a ping or to change the source interface on a permanent basis ?

bej · 11-22-2004

I figured out the problem. There was a problem with the label forwarding table at the first PE router. I owe my thanks to Rajiv Asati, excellent MPLS VPN troubleshooting guide. I used OSPF as the IGP protocol and there was no problem with iBGP VRF e...

bej · 09-25-2004

Thanks for your replies. I tried to use per-packet loadsharing, it did not make a difference. I am using Pcattcp to measure throughput from PC 2 to PC 1. With both interfaces on LabD up i get about 116KBytes/s, with interface serial 1 shutdown i get ...

bej · 09-25-2004

Here is the diagram

Member Since	‎09-07-2004 11:12 AM
Date Last Visited	‎08-18-2017 03:51 AM
Posts	13

User Statistics

User Activity

Using MQC, cannot get the "Set" subcommand listed

Class subcommand "Set" not available

Hub and spoke vpn topology, OSPF downward bit propagation

How can i pin outgoing interface ip address with RT and/or loopback int. ?

PE-CE problem

Re: Class subcommand "Set" not available

Re: How can i pin outgoing interface ip address with RT and/or l

Re: PE-CE problem

Re: Problems with load balancing, EIGRP

Re: Problems with load balancing, EIGRP