I ave a brand new 9300 with very little configuration on it. When I get new switches I give them a bogus IP, configure a trunk port, and connect them to my network. Once I have connectivity I use VTP, and begin configuring the switch.
I did tha...
So this morning I fired up the switches, and tried pinging from Source VLan1 and it worked! Now it is responding to pings from the core as well as from the switch to the core.
Thanks for your help on this. Not sure what the issue was but it seems...
I console directly into the switch from a PC. No network connectivity there.
I have the switched plugged into a network cable that goes to our Core. Both ports the one on the new switch, and the one on the Core are configured for Trunking. I the...
Here is the sho run with some minor things redacted...I've been plugged into gi 2/0/24
Current configuration : 6529 bytes
!
! Last configuration change at 14:34:57 UTC Tue Apr 3 2018 by admin
!
version 16.6
no service pad
service timestamps debug...
