Hi there,
I would need your experience to determine if some behavior documented in the ACI L3 Config Guide is true or if I am reading it wrong. The document is here and the statement is:
Spoiler
When Allow all (0.0.0.0/0 with aggregate flag) is...
Hello,
We have been requested to install custom certificates for our 3 Cisco APICs. We have followed this guide : https://www.cisco.com/c/en/us/td/docs/switches/datacenter/aci/apic/sw/1-x/basic-config/b_ACI_Config_Guide/b_ACI_Config_Guide_chapter_0...
Hello,
We are still fighting to finish the integration of UCS + VMWare + Cisco ACI.
We have been working hard and now we find a bit of a surprise:
The Fabric Interconnects, 2 of them, are linked via VPCs to a pair of ACI Leafs. All is fine, the...
Hi everyone,
I have found, possibly, a bit of an issue.
Our Cisco APIC use exclusively OOB management. In order to join the vCenter server to deploy magically the DVS, the APIC has no other choice but to use the OOB network.
However, the vCente...
Hi everyone,I have found, possibly, a bit of an issue.Our Cisco APIC use exclusively OOB management. In order to join the vCenter server to deploy magically the DVS, the APIC has no other choice but to use the OOB network.However, the vCenter server ...
Hello, Regarding question 1), you can converter up to 4 of the 6 QSPF uplinks on the switch. Here is a document on how to perform this conversion. https://www.cisco.com/c/en/us/td/docs/switches/datacenter/aci/apic/sw/2-x/L2_config/b_Cisco_APIC_Layer_...
Hi,
This might not be the total solution, but I guess that applying RouteMaps could allow you to tag the BGP Community as needed.
https://www.cisco.com/c/en/us/td/docs/switches/datacenter/aci/apic/sw/2-x/L3_config/b_Cisco_APIC_Layer_3_Configurati...
Hello,
This would seen a case for Transit Routing using OSPF, possibly using the same Border Leaf.
Some information:
https://www.cisco.com/c/en/us/td/docs/switches/datacenter/aci/apic/sw/1-x/aci-fundamentals/b_ACI-Fundamentals/b_ACI-Fundamentals...
Hello,
I am having some trouble understanding your case. As I understand, ACI will be the GW for the Endpoints connected there (so far, ACI is layer2 so the GW for those subnets is elsewhere), but then you mention that the FW will be the GW for the...
Hi there,
In my case, it had to be the very first user that tries to login. Reboot the APIC and at the first login prompt enter 'rescue-user'.
Wait a bit until the system is fully operational. I kept typing every now and then the '?' key until I st...
