About wrwiii122

wrwiii122 · 11-13-2014

I normally use 5520's but need to use a 5505 and realized it is a little different and can not do sub interfaces. I have read that I can trunk an interface but how do I assign IP addresses to each of those VLANs on that trunk so that it can NAT? Cu...

wrwiii122 · 01-29-2008

I have read some docs on this but dont really see how to do it yet. I have three sites, A, B, & C. A has a 2620 with 2 T1 WICs connecting to B & C. B & C each have a WIC connecting to A. On the ethernet side there are 3550's. At each site there ...

wrwiii122 · 10-04-2007

I it possible to have a dual WAN with PIX515E so that if one goes down the other will take over to allow internet to always be up. Also is it possible to have the pix choose which internal network to send the vpn client to depending on the login. I...

wrwiii122 · 09-28-2007

I have attached my config and took out the ip and password info. I am trying to setup a webserver and remote desktop connection on 3390 but the logs keep stating that incoming connections are being blocked the the inbound ACL. Can someone tell me w...

wrwiii122 · 09-27-2007

Maybe I just don't really get what is going on but why is it that the PIXs seem so hard to configure? I use netgear, linksys, juniper, and many other firwalls and they are so easy to configure. When it comes to the pix I cant even figure out how to...

wrwiii122 · 11-16-2014

The GUI was not working very well to make things happen right. Using the CLI solved the issue.

wrwiii122 · 09-29-2007

That didn't seem to work. I am using PIX 8.02 and the error I get is "ERROR: IP address,mask doesnt pair". So I added this but it still is not working "access-list outside_int extended permit ip host xx.xxx.xx.x interface outside".

wrwiii122 · 09-28-2007

I was trying to do the same thing and couldnt get it to work. I found out that I cant see where to have a local ca server so I reverted back to the CLI. You have to input ca generate rsa key 1024 and then ssh will work.Hope this helps.

wrwiii122 · 07-10-2007

You will have to get with your ISP and set it up with them and they will give you the config that you should use to communicate between the systems.

wrwiii122 · 07-08-2007

So I guess when you order it you have to send Cisco, or whoever you buy it from, some code from the box and then they send you a key? I would really like to get a handle on how this licensing system really works. The Microsoft licensing is public i...

Member Since	‎09-30-2004 11:12 AM
Date Last Visited	‎08-18-2017 03:51 AM
Posts	240
Total Helpful Votes Received	5

User Statistics

User Activity

ASA 5505 Subinterface Equivalent

VLAN Bridging Across T1 2600's

515E Dual WAN Multi VPN

Help with config

PIX is so difficult

The GUI was not working very

Re: Help with config

Re: SSH management on Outside interface

Re: Redundant ISP/DNS connection

Re: PIX 515E Licensing