About sbjeong

sbjeong · 01-21-2010

Cat2950T-24 ___(link1)_____cat2950<ios ver.>cat2950T-24: 12.1(13)EA1cat2950 : 12.1(22)EA8a1) link1 down2) I could find logs the following in the cat2950T-24 SPANTREE-7-RECV-1Q-NON-TRUNK: SPANTREE-7-BLOCK-PORT-TYPE:3) port, stp configurations are ...

sbjeong · 08-01-2006

Is it possible ?<Case>Platform: IOS Router or L3 SwitchDoes it possible that Static NAT a packet ,source and destination at a time.ex) svrA IP:1.1.1.1 rtr IP:1.1.1.100 IP:2.2.2.100 svrB IP:2.2.2.1svrA-rtr-svrB (physically)svrA a packet...

sbjeong · 11-10-2005

CPU Utilization is around 80% and redundancy state is wrong.But Active Sup-IV is still normal.Help me.I attached a reference text.

sbjeong · 07-04-2005

Hello,I'd like to limit downloading traffic around max 2Mbps. So I configured like below. But, traffic is wave, no steady 2Mbps, so it looks like something wrong.How can I make it correct ?10.9.5.28 is my PC IPAddr.---------------------------------#s...

sbjeong · 04-21-2005

C6006, native IOS, c6sup12-js-mz.121-23.E2.binafter "write mem", strange messages are generated" Mac Move feature not supported " what means ?refer to following dumpRouter#wrBuilding configuration... Mac Move feature not supported[OK]Router#

sbjeong · 01-21-2010

I didn't configure the ports "switch mode access" on both switches, so they operate in trunking (802.1q) Cat2950 only support 802.1q

sbjeong · 01-21-2010

Sorry, customer's policy don't allow it.Almost configuration is factory default, and port/stp configuration is factory default.

sbjeong · 08-01-2006

please read my question to the last phase.Does your reply say that a packet SRC,DST NAT at the same time as my case?

sbjeong · 07-06-2005

Thank you for your repliesalfredshum , Kevin.Dorrell, kumarapalani Dear kumarapalani My NIC is 10/100Mbps therefore 5% means 5Mbps.Dear alfredshum I've already tried set only CIR at the first time, but it was same pattern and lower bandwidth. And in...

sbjeong · 07-05-2005

I've confured it at the first time, but it was same pattern and lower bandwidth.

Member Since	‎11-05-2001 01:26 AM
Date Last Visited	‎01-23-2024 08:23 AM
Posts	44

User Statistics

User Activity

Cat 2950 Switch port down problem

NAT

C4507R w/ 2* Sup IV redundancy failure and High CPU Util.

qos problem

C6006 message

Re: Cat 2950 Switch port down problem

Re: Cat 2950 Switch port down problem

Re: NAT

Re: qos problem

Re: qos problem