About ricardolainez

ricardolainez · 09-04-2012

Ok so I'm taking the Cisco Switching course and I'm currently at VACLs, but have found that I can't quite get them to work the way I want to.Basically what I'm trying to do is to apply a VACL at a certain access layer switch so that a specific PC can...

ricardolainez · 12-11-2011

Here's the situation, I hope someone can help me with this.I'm implementing PBR on a multihomed network with 2 ISPs. ISP1 is the preferred exit to the internet, while ISP2 is used only for backup purposes.There is however low priority traffic from a ...

ricardolainez · 09-05-2012

Hey Peter,Sorry, I did another take on your first reply and I understood your meaning much better. I won't be able to test this until later today but I will try to do IP ACL only, which is the one thing I have left to try. Thanks again.

ricardolainez · 09-05-2012

Thanks Alessio,According to that documentation, VACLs should be able to use IP addresses for filtering, but it won't work =(There's also the option of using Port-ACLs, and I will also try that, but I would like to make it work with a VACL, or at leas...

ricardolainez · 09-05-2012

Thanks for your reply Peter. I'm actually using a 3550, I'm not sure about the IOS version but I will post it here as soon as I confirm it.As I mentioned in the original post, I also tried the filtering using only MAC addresses, the configuration was...

ricardolainez · 12-11-2011

Well, the thing is traffic should only be PBR'd when its for unknown destinations (using default next-hop), meaning when it's going to take a default route, cause this would be internet traffic. Traffic for known destinations would be local and shoul...

Member Since	‎12-11-2011 08:41 AM
Date Last Visited	‎08-29-2018 12:01 AM
Posts	6

User Statistics

User Activity

VACL not filtering based on destinations.

PBR with IP SLAs

Re: VACL not filtering based on destinations.

Re: VACL not filtering based on destinations.

Re: VACL not filtering based on destinations.

PBR with IP SLAs