About jwilde

jwilde · 11-06-2018

What would be the equivalent on xr to do a max paths statement. I believe on ios it is maxas-limit.

jwilde · 05-10-2018

this is an example. My question is should i do an explicit acl also here with ipv4 access-list BCP38...

jwilde · 05-09-2018

does not ipv4 verify unicast source reachable-via rx cover doing ingress access-list on the access e...

jwilde · 02-14-2018

thank you. i was going to create a tunnel, but thought it was useless since it would be the same pat...

jwilde · 02-13-2018

on ios xr i should have put in there.

jwilde · 02-13-2018

i have a pretty simple setup, but am not sure how to pass a route through iBGP from and iBGP peer to...

jwilde · 02-08-2018

my bad on this. it is an asr9010 using ios-xr. I can't send it to two destinations without it erasin...

jwilde · 02-07-2018

is there a way to do multiple destinations on netflow data on interfaces? I'm trying to do this beca...

jwilde · 01-22-2018

can you give me an example? i haven't found anything that supports that but that was my goal.

jwilde · 01-19-2018

this is on ios-xr i forgot to add that.

jwilde · 01-19-2018

I have a situation where i have a default vrf and a Video vrf. Is there a way without BGP to route b...

jwilde · 11-14-2017

well the goal was just to have bgp running on the router and no interior gateway protocol if i under...

jwilde · 11-14-2017

i'm pretty sure (i just put on the rfc ip address, but my loopback is loopback 192.168.3.1/32 interf...

jwilde · 11-14-2017

Well unalloyed I forgot to change the ips the neighbors are /30. So the router I'd should be one of ...

jwilde · 11-14-2017

I normally do out as loopback

Date Registered	‎06-08-2005 07:33 PM
Date Last Visited	‎11-13-2019 01:37 PM
Total Messages Posted	62
Total Helpful Votes Received	7

ios xr bgp equivelant of ios