About ranilf2005

ranilf2005 · 09-06-2012

Hi,Can anyone advice, whether VSS technology support on 3560 switches.I'm planning to intergrate new Cisco 2x6509 with VSS and all the access swtiches 3560's uplink to core 6509if not support, whar will be the solution or any bug fixing or new IOS re...

ranilf2005 · 05-27-2008

Hi,Is there any possibility of configuring the both LDAP and the RSA(SID) for authentication (Basically it should be first authorize from the LDAP and second from the RSA ID) ?

ranilf2005 · 03-31-2020

Some area to check and TS1. Local user setup and configuration2. VPN Split-tunnel Configuration3. Routing (Sync/Async, etc.)4. Local Firewall, AV configurations5. Group policy

ranilf2005 · 03-31-2020

Please find below some guidance document for Split-tunnelling configuration.https://www.cisco.com/c/en/us/support/docs/security/asa-5500-x-series-next-generation-firewalls/100936-asa8x-split-tunnel-anyconnect-config.html https://www.cisco.com/c/en/us...

ranilf2005 · 03-13-2018

Are you using any L3VPN with dynamic routing or can you post the config

ranilf2005 · 03-13-2018

When you using PBR, you have to select specific Source address to route to specific next-hop. Did you specify which source subnets you need to go via MPLS and ISP1 (as per ACL its Allowed all Source) ? Did you want to apply conditional static route...

ranilf2005 · 03-13-2018

Please check your encryption domain access list is allowed the loopback IP you want to source ? also try to run "sh cry ipsec sa" to see the allowed traffic via the IPSec tunnel.

Member Since	‎09-02-2007 08:49 PM
Date Last Visited	‎04-01-2020 04:53 AM
Posts	19
Total Helpful Votes Received	5

User Statistics

User Activity

Cisco 2x6509-E VSS with Aggregation 3560 switches

VPN LDAP and RSA dual Authentication

Re: AnyConnect Issue with Personal W10 Computers Accessing Network Resources

Re: New Question on AnyConnect Split Tunnel Setup for O365

Re: VRF CONFIGURATION IN OSPF MPLS

Re: route-map configuration

Re: NAT on a Loopback0 Interface