UCrypto
Level 1
Level 1
Member since ‎04-06-2018
‎05-27-2022

User Statistics

  • 98 Posts
  • 1 Solutions
  • 695 Helpful votes Given
  • 15 Helpful votes Received
Recent Badges
10 Helpful Vote
1 Helpful Vote
50 Replies
20 Replies
1 Accepted Solution
10 Replies
5 Replies

User Activity

Dear all, I try to vti in my lab. I got the some issue. i cannot turn on "tunnel mode ipsec ipv4" in tunnel. If i active that command my traffic cannot reach end to end (host to host) I remove this command,i can reach host to host. it is VTI restrict...
Hi,I have confuse in network design.Please see below diagram and please help me how to fix to get fully redundancy.In diagram,If WAN link of R1 is down,branches can detect WAN link of R1 is down and so they swing their traffic to R2. But our VRRP did...
Dear all , I would like to know stupid question.I have the problem to integrate existing network and HA firewall. please see below diagram and let me know can i conbine two routed interfac to one virtual IP ? it is not mean vrrp. i mean i want to run...
Hi , I am using Meg@pop service without internet service. But my network is very slow and unstable. I don't know how to test how much network speed .I know ping test only. Please help how to test is it local network issue or Meg@pop issue ? How to te...
Dear Sir, i would like to ask about 802.1x authenication . i try to configure 802.1x Configure Wired 802.1X with NPS without using ISE or third-party appliance. I watched youtube training video and i followed these tutorials. But when i am testing,i ...
Community Statistics
Member Since ‎04-06-2018 07:59 AM
Date Last Visited ‎05-27-2022 12:05 AM
Posts 98
Total Helpful Votes Received 15
Helpful Votes From