niko
Level 1
Level 1
Member since ‎11-13-2015
‎02-14-2024

User Statistics

  • 62 Posts
  • 5 Solutions
  • 10 Helpful votes Given
  • 54 Helpful votes Received

User Activity

Pretty basic AnyConnect config, GroupPolicy: group-policy XXXX attributesdns-server value <DNS1> <DNS2>vpn-filter value <FILTER>vpn-tunnel-protocol ssl-client split-tunnel-policy tunnelspecifiedsplit-tunnel-network-list value <SPLIT_POLICY>default-do...
FPR-1010 with ASA 9.14(1)30.Clientless VPN is not showing any bookmarks (there's simply section showing up, multiple browsers), even though they have been configured in the DAP & GP and debugs are showing that they have been applied after the user lo...
Basically, there is a requirement of receiving device-public-mac attribute in order to check the device compliance against MDM based on the MAC address, but even though some of the PCs are sending this attributes, mobile devices are not. It was teste...
What's the best way to configure static active/passive MAC address for a failover pair? Asking, because there are basically two ways:1) Under FTD interface configuration -> Advanced -. Active/Standby Mac address.It is then being applied like this dur...
After doing upgrade from 6.2.3.5 to 6.2.3.7 for 2100 series FTP box failover pair new FXOS alarm showed up:   Severity: MajorCode: F1329Last Transition Time: 2018-12-06T17:20:52.586ID: 555499Status: NoneDescription: Ntp Configuration failed, please c...
Community Statistics
Member Since ‎11-13-2015 06:37 AM
Date Last Visited ‎02-14-2024 12:05 AM
Posts 62
Total Helpful Votes Received 54
Helpful Votes Given To