About bhuffy

bhuffy · 10-02-2018

Hello all, I'm looking to gather some thoughts to determine if this is possible or not.. I currently have an AnyConnect VPN configured on my ASA and it's working fine. I'd like to be able to be able to access my l2l offices without updating the ph...

bhuffy · 10-04-2018

After reapplying the NAT statement, I found every to be working as expected.. I must've just overlooked something during my initial testing.

bhuffy · 10-03-2018

The remote peer is a small business vpn router (Linksys). The remote office is allowing the entire /24 and other hosts on the LAN are able to reach devices on the remote LAN (and vise versa). I'm going to see what sort of diagnostics I can perform on...

bhuffy · 10-02-2018

Thanks for the reply. Here are the nat statements for the sslvpn. I am hung up on the second rule. SSLVPN net - n_10.255.1.0_24Remote office - n_192.168.21.0_24 Inside/local net - n_192.168.10.0_24Unused IP on LAN for SNAT - h_192.168.10.3 # no-n...

bhuffy · 10-02-2018

Hi Marius, thanks for the reply. I did try using a spare IP on the inside during my testing without success. To confirm, I do have "same-security-traffic permit intra-interface" applied.

Member Since	‎04-08-2018 05:49 PM
Date Last Visited	‎10-11-2018 09:27 AM
Posts	5

User Statistics

User Activity

Cisco AnyConnect to NAT for L2L tunnels

Re: Cisco AnyConnect to NAT for L2L tunnels

Re: Cisco AnyConnect to NAT for L2L tunnels

Re: Cisco AnyConnect to NAT for L2L tunnels

Re: Cisco AnyConnect to NAT for L2L tunnels